Stone engraving machine common troubleshooting method

For the stone engraving machine, if there is a fault, it will affect the progress of the whole work, which requires us to find out the cause of the fault and the solution as soon as possible. The following article focuses on several common faults of the stone engraving machine.

1. The machine can not be returned to the zero position and the engraving machine is reduced or out of bounds: the machine head cannot be returned to the zero position. The lead screw may be misaligned. The screw must be adjusted: the machine head cannot be returned to the zero position and the engraving machine is reduced in size or out of bounds. "Model" does not match the actual model

2, stone engraving machine running knife: no installation of ground wire, static electricity, resulting in running knife, misplaced, need to install the bottom line; the software parameters in the printer and the engraving machine printing parameters do not match the correction.

3, stone engraving machine often cut the hard material when cutting the knife: when carving hard materials, you need to set different engraving parameters according to different materials, use different tools; choose the appropriate lubricant.

4. When the stone engraving machine starts to reset, it will beep or always top the limit switch: the top of the pole is less than the limit switch, and it can be corrected; the drive line is not in good contact, try to fix the drive line firmly; The bit switch wire is not connected, the wire can be connected; the limit switch is broken, and it can be replaced.