Teach you how to use the tool of woodworking machine?

    1. Acrylic cutting processing, it is recommended to use single-blade spiral milling cutter. It is characterized by smokeless and odorless, fast, high efficiency, non-sticky, and truly environmentally friendly. Its special manufacturing process guarantees that processing acrylic does not blast. Long-lasting fine knife pattern (even without knife), the surface is smooth and flat. The surface needs to be frosted. It is recommended to use a double-edged three-blade spiral milling cutter.

    2, MDF cutting processing, it is recommended to use double-blade large chip spiral milling cutter, it has two high-capacity chip flutes, double-edged design, not only has a good chip removal function, but also achieves a good tool balance. When processing high-density boards, it does not black out, does not wear a cigarette, and has a long service life.

    3, aluminum plate cutting processing, it is recommended to use a single-blade special aluminum milling cutter. It does not stick to the knife during processing, and it has high speed and high efficiency.

    4, precision small relief processing, it is recommended to use a round bottom knife.

    5, cork, MDF, native wood, PVC, acrylic large deep relief processing, it is recommended to use a single-blade spiral ball end mill.

    6, no burr cutting processing above, it is recommended to use a single-blade, double-edged upper and lower cutting cutter.

    7, high-density board, solid wood is recommended to use a tooth milling cutter.

    8, multi-layer board, splint processing, it is recommended to use double-edged straight slot milling cutter.

    9. The use effect of the lower cutter, the upper surface of the processed product has no burrs, and will not be rocked when processed.

    10. It is recommended to use diamond engraving knives for acrylic mirror engraving.

    11. Multi-strip milling cutters are recommended for roughing particleboards.

Woodworking engraving machine analysis of some faults

The computer can't find the removable disk, the machine can't find the removable disk, and the data can't be transmitted.


(1) Check if the USB data cable is connected and the engraving machine is online.


(2) Confirm whether the removable disk format is FAT format, whether it is registered on the machine. The operation is correct.


(3), the machine control system is faulty.


The engraving works normally, but there is a chaotic phenomenon. (not engraving according to the designed image)


(1) Check whether the graphic design software parameters, the designed image file are correct, and the processing path parameter setting is correct.


(2) Whether the application software is good or bad, whether the design software used matches the engraving machine used.


(3), strong electricity, signal interference. Check whether there is strong current around the strong magnetic field. Check if the machine is well grounded.


The engraving machine loses the step when calling the stored machining origin or engraving.


(1) Check if the processed workpiece is loose. The operation is correct.


(2) Whether the speed is too fast when calling the origin. (The speed is adjusted according to the performance of the machine)


(3) Check whether the transmission parts of each axis of the engraving machine are loose.


(4), the machine control system is faulty.